Warranty & Aftercare

Looked After, Long After


What every product is covered for, what keeps that cover in place, and who to ring when something needs putting right.

Rated Excellent on Trustpilot

The Cover

What We Warrant


These apply to products supplied and, where we fit them, installed by Timber Windows Essex, timber, aluminium and uPVC windows and doors, sliding sash windows, bi-folds, roof lanterns, composite doors and sealed units, from Sheerline, Korniche, Aluco, Liniar, Sunflex, Masterframe, Evolution.

Aluminium & uPVC

Sheerline · Korniche · Aluco · Liniar · Sunflex · Masterframe

Structural defects & manufacturing faults

10 years

Aluminium extrusion, Qualicoat

10 years

Aluminium extrusion in marine environments

5 years

Glass against breakdown

10 years

Hardware

10 years

Timber

Painted and stained timber windows & doors

Timber against rot & fungal decay

30 years

Paint finish

12 years

Stain finish

6 years

Glass against breakdown

10 years

Hardware

10 years

10 years

Installation, too. Where our own teams fit your order, the workmanship carries a ten-year warranty covering installation defects, water ingress caused by the installation and incorrect fitting. It does not apply to supply-only contracts, where we deliver to site and your own installer takes it from there.

Your Part

What Keeps It In Place


None of it is difficult. The warranty asks that the coating is kept intact, and the coating is kept intact by washing it, twice a year for most houses, at the same time as the windows are cleaned.

Regular cleaning lifts off the dust, insects and deposits that algae and fungal growth need to get started, and it gives you a look at the finish while you are there. What it must not involve is a hose pipe or a pressure washer.

A painted timber flush casement window in good order
A close-up of the joinery and ironmongery on a timber casement window

Timber

Painted and Stained Finishes


Your joinery leaves the factory with a base primer and two coats of a microporous system. How long that lasts depends on the elevation and how exposed it is, but the finish is built to protect for twelve years painted and up to six stained.

  • Wash with hot water and a mild detergent, changing the water as it dirties
  • Rinse with clean water and wipe dry
  • Clean more often on north-facing, coastal or polluted elevations
  • For any fungal growth: one part household bleach to two parts water, twenty minutes, then rinse thoroughly
  • Resin weeping from a knot is natural in timber and is not a fault

Teknos paints and stains give the closest match when you come to touch up or redecorate, though any good microporous system will do.

Decorative sash horns on a painted timber sash window

Aluminium, uPVC and Hardware

Coatings and Ironmongery


Powder-coated aluminium and uPVC want the same treatment on a slightly different clock, and the ironmongery has rules of its own depending on the finish.

  • Wash frames every six months, every three near the coast or heavy industry
  • Warm water and a non-alkaline detergent, on a soft cloth, sponge or soft brush
  • Wash out the grooves, joints and drainage channels where salt collects
  • Inside faces at least once a year
  • Lacquered brass: never metal polish or abrasives, they take the lacquer off
  • Unlacquered brass is meant to dull down; polish it back with a dry cloth if you prefer it bright
A cottage with white painted timber casement windows

Once a Year

Look While You Clean


The wash is also the inspection. Once a year, take a proper look at each window and door while it is wet and the dirt is off, it is the only time the finish is easy to read.

Anything you find should be put right straight away rather than left until next year. A chip touched up in an afternoon stays a chip; the same chip left through a winter lets water into the timber, and that is a different job altogether, and the point at which cover starts to be affected.

  • Look along the horizontal surfaces first, cills and bottom rails weather hardest
  • Touch up any chips or worn patches without delay
  • Check the draught seals are seated in the rebate, with no splits or tears
  • Wipe hardware with a soft cloth only, never wire wool or scouring agents
  • Report anything you are unsure about; advice costs nothing

Coastal Homes

Nearer the Sea, More Often


Salt air is harder on paint and hardware than anything inland, which matters along our stretch of the Essex coast. If you are near the water, this is the schedule to work to.

Exterior woodworkEvery 3 monthsAgainst twice a year inland
Exterior glass and sealsEvery 3 months
Handles and letter platesMonthlyThe parts the salt reaches first
Exterior hinges and locksEvery 3 months
Interior woodwork, glass and sealsAnnually
Interior hardwareEvery 6 months

Before We Fit

While the Building Work Is Going On


Factory-finished joinery is easy to damage on a live site, and most of the damage we see is avoidable. If your project has trades still working, these are the ones that matter.

  • Cover with breathable materials only, polythene traps moisture against the finish
  • Use low-tack tape, test it first, and take it off the same day
  • Store off the ground, covered, dry and ventilated
  • Keep joinery out of metal site containers
  • Let plaster, render and screed dry before we install
  • Wash off any building materials straight away with mild detergent

We send the full guidance out with every order, and your project manager will talk it through before delivery.

A cottage with white painted timber casement windows

Straight Answers

What Is Not Covered


Every warranty has limits, and we would rather you read ours here than find them later. Liability is limited to repairing or replacing the defective parts, and does not extend to redecoration or consequential loss.

  • Fair wear and tear
  • Cosmetic damage not reported within 14 days
  • Glass scratches not reported within 7 days
  • Misuse and accidental damage
  • Structural movement of the property
  • Condensation on glass surfaces
  • Minor optical distortions within industry tolerances
  • Third-party alterations
  • Storm damage beyond design limits
  • Lack of maintenance in line with the care instructions
  • Corrosion in marine environments, unless marine grade was specified
Katie King, Service Coordinator

Katie King

Service Coordinator

Claims come to Katie, in writing, with photographs and the installation details. We may ask to inspect before authorising the work. katie@timberwindows-essex.com · 01206 580 388. Or email enquiries@timberwindows-essex.com and it will reach her just the same.

And Also

Worth Knowing

  • This warranty is in addition to your rights under the Consumer Rights Act 2015
  • Report anything visible as soon as you spot it, small problems stay small
  • Cosmetic damage must be reported within 14 days, glass scratches within 7
  • Keep a record of your cleaning and maintenance
  • Katie is your point of contact for as long as you own them
  • Advice is free, whether or not it turns into a claim
Inside our Leigh-on-Sea showroom

See the Quality for Yourself


Visit one of our five Essex showrooms, or send us your plans and we will prepare a detailed quotation.